Start-Remover Kit. One Step

19,95

Start-Remover Kit for permanent nail polish.

Composed by: CLEANSER Eliminates residue + special nail polish REMOVER + 3-Phase nail and cuticle oil Nail Treatment + professional precision file + Gentle buffing block + Manicure stick + Cloths + Aluminium foil with cotton cloth + Step by Step flyer.

Category: Tag:

Description

Start-Remover Kit for permanent nail polish.

Composed by: CLEANSER Eliminates residue + special nail polish REMOVER + 3-Phase nail and cuticle oil Nail Treatment + professional precision file + Gentle buffing block + Manicure stick + Cloths + Aluminium foil with cotton cloth + Step by Step flyer.

PERMANENT POLISH STEP-BY-STEP APPLICATION

  1. Remove all traces of shiny or traditional nail polish using Remover. Wash and dry the hands.

Correct preparation of the nails is crucial for a good result and a long-lasting effect!

  1. Be careful to push the cuticles back well, using the flat end of the manicure stick.

(Even if there is no obvious cuticle do not ignore this step, as there is always a layer of skin that can be invisible, which will make the polish irregular).

  1. Shape the nail using the fine side of the file.

(Even if the nail is the desired length, it is important to file the edge a little to improve the surface for adhesion and duration of the colour).

  1. Gently polish the surface of the nails with the buffing block, to increase porosity for better colour adhesion.

(Pay special attention to the area around the cuticle and the sides of the nail).

  1. Use a mask.

Apply a sufficient amount of Cleanser with a soaked cloth and scrub each nail to clean thoroughly, remove oils and eliminate any trace of product.

Shake the nail polish well for optimum intensity, texture and coverage.

Begin application of each coat of polish with the thumbs and dry under the lamp. Then apply each coat to the other four fingers of one hand and dry under the lamp. Repeat the process for the four fingers of the other hand.

  1. Using the side of the selected One Step Polish colour brush, paint the edges of the nails, covering them completely.

Put the nails under the LED lamp and switch on with the top switch to dry the product.

The lamp will turn off automatically after 30 seconds.

  1. Wipe any excess product from the brush inside the bottle neck and apply a fine, precise and even coat of polish, leaving a space of about half a millimetre so that the polish does not touch the cuticle or the skin around the nail:
  • Put a drop in the centre of the nail and push it downwards using the form of the brush to make a perfect curve without touching the cuticle. Then brush upwards.
  • Twist to one side with a brush stroke downwards, and repeat on the other side.
  • Apply to the tip of the nail passing the brush over the edge to seal the colour.

Dry under the lamp for 30 seconds.

If the polish gets too hot under the lamp, remove the hand for two seconds, and replace until the polish is dry.

  1. Remove the hand from under the lamp and apply a second coat of colour, using the same method.

Dry under the lamp for 30 seconds.

  1. Optional: to fix decorations or if the nails frequently come into contact with aggressive products, apply a coat of Top Coat to seal the edge of the nails.

Dry under the lamp for 30 seconds.

Soak a cloth with Cleanser and clean the sticky layer of Top Coat from the nails where applied.

  1. To hydrate and nourish the cuticles apply Three-Phase Oil using a brush and massage in with the fingers until completely absorbed. Apply whenever desired while the colour remains.
  2. To moisturise the hands, gently massage in Neutralia Cream.

 

 

 

Reviews

There are no reviews yet.

Be the first to review “Start-Remover Kit. One Step”

Your email address will not be published. Required fields are marked *

TOP